Skip to main content
Studio Tuuri

Residential Lighting Design

Installation Review, Aiming, and Commissioning

A lighting plan is not finished when the fixtures are installed. Adjustable fixtures arrive pointing straight down, dimming ranges sit at factory defaults, and scenes are empty.

Commissioning verifies the design against the room: locations checked, substitutions caught, every adjustable fixture aimed after dark, dimming limits set, scenes built with you present. The least expensive step to get right, the most expensive to skip.

The work

What we actually do.

  • Verify what was installed matches what was specified — substitutions arrive unannounced.

  • Aim every adjustable fixture after dark, on the surface it is meant to light.

  • Set dimming limits so nothing flickers or drops out at the low end.

  • Build the scenes with you, then walk the system so you can run it yourself.

How this differs

Not what your electrician or showroom provides.

  • This is the step nobody owns: the electrician is done, the builder is done, and the fixtures are still pointing at the floor.

See how a project runs, step by step

Questions

Common questions.

Make lighting part of the design—not an afterthought.

Tell us about the project—the stage it is at, what is already decided, and what is bothering you. We will tell you honestly whether we can help and what that would involve.

Rio Grande Valley and South Texas · kevin@studiotuuri.com